Trend Hinge Jig A - Two piece jig for quick, accurate repeatable fitting of hinges to doors and frames (H/JIG/A)

The two part Contractor Hinge Jig is a portable template set designed for recessing hinges in wooden doors & frames using a plunge router.|It is easy to use with minimal setting-up time, completing the job both accurately & quickly.|Used on-site & in joinery shops to increase productivity with excellent results. |Four apertures for fire door requirements. |No need for marking out in the conventional way. |Quick & simple to set-up as the hinge is used as the pattern.|Clean & accurate recesses are achieved every time. Suitable for timber based doors & square butt hinges.|Can be used on both inside and outside doors, rebated frames and on maximum 25mm thick fixed stops.|Use with a light duty plunge router with 1/4 inch collet.|Long reach router cutter required, 12mm diameter with 70mm overall length.|Angled position slots to prevent creep.|Unibase may be needed.|T4EK router requires a ref. UNIBASE or special guide bush ref. GB/T4/160.

Specification:
Length min.=2 5/8" (67 mm)|Length max.=5" (127 mm)|Width min.=3/8" (9.5 mm)|Width max.=1 3/8" (35 mm)|Width max. in 35mm rebate=20 mm |Width max. in 44mm rebate=30 mm|Door sizes possible|Height min.=6' 5" (1955 mm)|Height max.=2100 mm*|Thickness min.=5/8" (16 mm)|Weight=3.3 kg|Jig overall length=1957 mm|Plate thickness=2 mm|Fixed stop max. thickness=25 mm**|* Please note for doors over 2040mm the bottom hinge will be higher than 9" up.|** Max. hinge leaf width 20mm (35mm doors)|Thickness max.=2" (51 mm)

4 x Apertures|2 x Bradawls with spacer|1 x 16mm guide bush|1 x T-Handle hex key 4mm|1 x 4mm spacing gauge|1 x Carry case

12 months