Pro Multi-material jig for worktop joints 150mm - 750mm|FRONT EDGE SETTING All settings are done from the front edge eliminating any discrepancies from scribing or when using non-standard width worktops|EASY SET REFERENCE WINDOW Fast set up for any backset, simply align to a measured line|5 BACKSET OPTIONS (3, 5, 10, 24, 35mm) to meet the demands of new materials, edge profiles and trends|FLUSH EDGE COMPATABILITY Allows worktops to be cut flush with door faces for handleless contemporary styles without additional measuring or marking up|SINGLE PASS JOINT CUTTING ON NARROWER BACKSETS WITH THINNER WORKTOPS Minimises strain on the router and extends cutter life|FAST JOINTING Cuts a full male and female joint in 15 minutes including setting up|MULTIPLE WORKTOP MATERIAL COMPATABILITY Compact laminate, Composite, Solid Wood, Chipboard Laminate|NO SET WORKTOP WIDTH RESTRICTION No need for alignment pins for worktop widths|FRUSTRATION FREE SETUP Simple intuitive setup; measure, mark, clamp and cut|OFFSET CAMS Unique backset wedges for consistent easy setting|EDGE PROFILE COMPATABILITY Covers square edge, small radius, Postform radius and bullnose profiles|CLAMP RECESSES For below the surface clamping for unrestricted routing with plunge saw clamps
Specification:
Length=985 mm|Width=335 mm|Thickness=12 mm|Weight=4.73 kg|End Cut=45 degrees|Corner Radius=40 mm|Corner Radius=100 mm|Corner Radius=400 mm|Corner Mitre Joint=45 degrees|Female cut material width loss (inset)=variable|Bolt recesses=3|Bolt recess centres=175 + 175 mm|Bolt recess width=14 mm|Guide bush=30 mm|Plunge router=1/2-inch (min. 1300 watts)|Cutter=12.7 mm x 50 mm cut|Clamps=Two|Patent Pending
4 x ABS Plastic pins|4 x Cams (pairs)
Specification:
Length=985 mm|Width=335 mm|Thickness=12 mm|Weight=4.73 kg|End Cut=45 degrees|Corner Radius=40 mm|Corner Radius=100 mm|Corner Radius=400 mm|Corner Mitre Joint=45 degrees|Female cut material width loss (inset)=variable|Bolt recesses=3|Bolt recess centres=175 + 175 mm|Bolt recess width=14 mm|Guide bush=30 mm|Plunge router=1/2-inch (min. 1300 watts)|Cutter=12.7 mm x 50 mm cut|Clamps=Two|Patent Pending
4 x ABS Plastic pins|4 x Cams (pairs)
12 months
